The Twin Beam LED Wall Light throws two soft fans of light, one up the wall and one down it, the same effect as a solar unit but wired into mains so the output never depends on the weather. It is small enough to sit neatly beside a door or to repeat along a wall in a rhythm. Lumen & Loam stocks it for anyone who wants that architectural line without the fade at two in the morning.
The body is ABS, up to about 6.9 inches, with an integrated LED so there is no bulb to replace. It runs on 85 to 265V and is hardwired with no plug, which means it needs an existing circuit at the mounting point. Installation by a qualified electrician is recommended. Four wattages let you match the light to the wall: 4W is enough to mark a doorway, while 10W will wash a two-story wall properly.
Choose 4W, 6W, 8W or 10W, each in warm light or cold light. Warm is the softer, domestic choice; cold reads crisper and more modern. Mount it beside a front or back door, repeat it along an exterior wall, run it up a stairwell, or use it indoors as an accent. It needs a flat surface above and below for both beams to land on. Wipe clean with a soft dry cloth.
- Output: 4W, 6W, 8W or 10W
- Light color: warm light or cold light
- Body: ABS, up to approx. 6.9 in
- LED: integrated, no bulb to replace
- Power: 85-265V, hardwired, no plug
- Placement: beside doors, along exterior walls, stairwells, indoor accents
- Safety: installation by a qualified electrician recommended
Electrical safety and certification
Certification status: we do not hold UL, ETL or CSA listing documentation for this fixture, so it should be treated as uncertified equipment. Many local electrical codes and some homeowner insurance policies restrict the installation of uncertified mains-voltage fixtures. Please check your local code before you buy.
Installation must be carried out by a licensed electrician. This is a mains-voltage product. Incorrect installation can cause electric shock or fire.
- Switch off power at the breaker and confirm the circuit is dead before starting work.
- Indoor dry-location use only unless an IP rating is stated in the specifications above.
- Do not exceed the maximum bulb wattage listed in the specifications.
- Do not modify the fixture, its wiring, its driver or the supplied mounting hardware.
- Stop using the product immediately if the cord, housing or terminals are damaged.
⚠ California Proposition 65 warning
WARNING: This product can expose you to chemicals including DEHP and lead, which is known to the State of California to cause cancer and birth defects or other reproductive harm. For more information go to www.P65Warnings.ca.gov.
